Keenovo Silicone Heater Pad
Size: 310mm x 310mm ( approx. 12.2" x 12.2")
Power: 750W
Accessories:
1m power cable(white)
Surface mount NTC 100K thermistor + 1m extension wire(red)
3M adhesive backing
4 pre-made screw holes as per drawing
Qty: 1 pc
Wonderful silicone heater for your Creality CR-10 3D printer build plate heating.
Rated at 5 watts per square inch with fast and even heating.
Equipped with NTC 100K thermistor ( Beta 25/50 3950K-1%) as temperature control sensor which is supported directly by Marlin firmware. ( Click Here also for thermistor R-T Datasheet.)
3M adhesive backing offers excellent and easy mounting onto most surfaces.
Versatile and may be used in many other applications.
Keenovo carries a full range of standard and custom designed silicone heaters, contact us if you need a special heater made for your machine.
Please heat only when after it's mounted onto the build plate (Aluminum plate recommended).
Any questions, message us. Response within 24 hours guaranteed.
Please contact us for special discount of large quantity purchase.
Custom Design Welcome.
General Introduction of Silicone Heaters
Heater Structure Illustration:
Please note that all silicone heaters are wire wound by default, Please contact us if you would like etched foil.
Typical Applications of Siliocne Heaters:
Copyright © 2019 Guangzhou Weyes Network Technology Co., Ltd. | All Rights Reserved