Voron 1.8 /2.4 3D printer Silicone Heatmat heater pad upgradeparts

The silicone heatmats were custom designed for Voron1.8 and Voron2.4 3D printer

These heaters are optimized for build plates shapes and hole positions. They allow even heating almost all the way to the edges of the build plate.

For added safety all heaters come with a self resetting bi-metal 150C thermostat. This turns off the heater if temperatures reaches 150 C due to technical failure of your electronics (only meant as a safety feature, not for temperature regulation).

Thermistor used is a NTC 100K thermistor (Beta 25/50 3950K-1%, 

Choose type 11 or 13 in Marlin firmware. Use "NTC 100K beta 3950" in Klipper.

The 250MM build size is  available 110V/220V    500W

The 300MM build size is  available 110V/220V    600W

The 350MM build size is  available 110V/220V    750W